Random good picture Not show

1. I mean, arc length could be positive or negative.

2. Nearly Arc Length parameterization curve palyes an important role in CAD and geometric modeling.

3. And, the speed is how much arc length on the curve I go per unit time, which is why I'm writing ds dt.

4. According to the principle of calculating meridional arc length, a novel practical formula is given in this paper.

5. Based on the mathematical model, the variation of arc length is bigger than that of wire extension.

6. The geometric progression technique and three dimension arc length technique are combined to form a new method.

7. For a given arc length, an ordered sequence of parameters that converge to the parameter of findpoint is found by bisection algorithm, thus nearly arc length numerical parameterization is implemented.

8. You should try a Nonlinear analysis, possibly with Arc length control method.

9. Actually, maybe you want to say that the arc length increases and then decreases along the curve.

10. The effects of cutting area, contact arc length, the geometry of cutting face, back dip angle of PDC cutter and rock performance on force of PDC cutter breaking rock were simulated experimentally.

11. Arc length method, an incremental method for solving non-linear FEM equations, is discussed and ap- plied in the paper.

12. An improved algorithm based on the equal arc length method is presented to solve substitutive arc parameters of spline hob curve section.

13. An auto - controlling system of arc length for AC - TIG welding with half-cycle arc voltage (workpiece positive) as a sensing signal is introduced in this paper.

14. Well, so in particular,how do you relate arc length and time?

15. Plane curves; tangent vector at a point, metric properties of plane curves (arc length, curvature).

16. This paper puts forward some practical formulae of measuring the area and arc length of arch form, and analyses the relative error of these formulae.

17. So, the next concept that I want to define is that of arc length.

18. So[sentencedict.com/arc length.html], the usual notation that we will have is for arc length.

19. In terms of the method of obtaining self-adapting dense data based on the curvature distribution and arc length bisection, the original points of shoe last were interpolated and smoothed.

20. Welding voltage power grid voltage fluctuations and changes in arc length self - adjusting ability.

21. The experiments show that the system can complete synergic control and arc length control.

22. I mean, that would be sneaky-freaky, but you could have a negative arc length that gets 0 closer and closer to zero, and gets to zero at the end of a trajectory, or anything you want.

23. And, what it does is it actually integrates the speed of the time to give you the arc length along the trajectory of the car.

24. This included angle, from port Alexander to Mr Thain of meridian arc length between two of the central angle.

25. APPLICATON: Straight edge, irregular curve edge, with adjustable speed feeding coder calculates arc length , auto - cutting function.

26. But, in this case, if you are moving back and forth, it would make more sense to have the arc length first increase, then decrease,increase again, and so on.

27. A new method of time dividing interpolation for machining ellipse was presented, and its principle is to divide interpolation section with equal arc length.

28. Then put the ruler on the surface of part's convexity and measure the arc length also with the numerical reading microscope.